Researchers in China have investigated how screen printing degrades copper-plated silicon heterojunction (HJT) solar cells and have developed an emulsion buffer layer intended to reduce mechanical damage during photoresist printing. The work targets a step that is important for lower-cost copper metallization but can affect the sensitive passivating contacts of HJT devices.
Screen printing is widely used for solar cell metallization, but in HJT cells the photoresist printing step differs from conventional silver paste printing. Corresponding author Lang Zhou told pv magazine that silver paste screens have openings covering only 2–5% of the total area, with an emulsion layer preventing direct mesh-wafer contact. Full-area photoresist coating typically uses a screen without emulsion coverage, so the mesh contacts the wafer extensively during each printing cycle.
Previous investigations cited by the researchers found conversion efficiency falling from 26.2% to 25.7% over 15,000 consecutive printing cycles in commercial solar cell production. The losses were mainly due to lower open-circuit voltage and fill factor, while short-circuit current density and electrical resistance remained largely unchanged. Minority carrier lifetime degradation rose from 0.61% with a new screen to 11.0% after 15,000 cycles.
Using three-dimensional confocal microscopy, the team identified progressive wear of the screen mesh knuckles as the main cause. As the knuckles wore down, their contact area with the wafer increased, placing greater mechanical stress on the underlying passivation layers. Scanning electron microscopy showed no visible surface scratches, but photoluminescence measurements confirmed increased recombination losses, pointing to damage at the amorphous silicon/crystalline silicon interface.
Emulsion coverage trade-off
To prevent direct contact between the mesh and wafer, the researchers developed an emulsion buffer layer and evaluated six patterns with emulsion coverage ratios from 2.9% to 16.6%. Higher coverage reduced damage but impaired photoresist coating uniformity, creating a trade-off between mechanical protection and ink distribution.
A coverage ratio of 4.7% provided the best balance in their tests, limiting minority carrier lifetime degradation to 0.41% after 10,000 printing cycles while maintaining relatively good coating uniformity. The researchers attributed the improvement to the emulsion layer preventing direct mesh-wafer contact and thereby reducing cumulative mechanical damage to the passivation layers.
Zhou said the findings showed that a relatively simple modification to screen design could substantially mitigate printing-induced degradation, offering a practical route to improving the manufacturing reliability of copper-plated HJT solar cells.
The results were presented in a paper titled Screen-printing photoresist induced efficiency degradation and mitigation in Cu-plated SHJ solar cells, published in Solar Energy.
Copper metallization context
The work comes amid growing interest in copper as an alternative to silver contacts in HJT cells. In April 2026, researchers at China’s Nankai University reported a silver-free HJT solar cell with 25.2% efficiency using plasma-induced interface engineering and copper electroplating. The approach addressed adhesion, contact resistance and stability challenges at the ITO interface.
Separately, scientists at Germany’s Forschungszentrum Jülich achieved 23.08% efficiency in a fully copper-metallized HJT solar cell. The silver-free device showed a relatively small efficiency penalty compared with its silver-metallized counterpart, while cells combining silver-copper paste on the front side with silver contacts on the rear reached 23.95% efficiency. Those results underline copper’s potential to reduce silver consumption, although further improvements in processing and electrical performance are still needed.
