The mid-engine Chevrolet Corvette C8 arrived with a dual-clutch automatic as its only transmission, a decision shaped by the cost of developing two transaxles for a mid-engine layout. Tremec, the supplier behind the six-speed manual used in several GM performance models, has demonstrated that a manual can fit the C8. The vehicle is not a factory-production model; it is a one-off development car built with Peitz Performance.
Tremec invited a small group of potential customers to sample its transmissions at Motorsports Gateway, a new private track outside Howell, Michigan. The C8 was a race build with a full roll cage, a racing harness and minimal interior finish. Its shifter sat where the production car’s storage cubby and automatic selector normally go. The test ran on a green track on a November afternoon.
Packaging the third pedal
Peitz did not need extensive changes to accommodate the gearbox. The transmission tunnel was cut to install clutch-pedal hardware, but the manual transaxle occupies the same space as the stock dual-clutch unit, with no special mating components. The pedal box also had enough room for a clutch pedal. The car’s seating position had virtually no adjustment; it suited a taller driver, making heel-and-toe downshifts awkward for a 5-foot-7-inch reviewer.
The shifter is remotely mounted and connected by cables, unlike the direct mechanical linkage in front-engine applications of Tremec’s TR-6060 six-speed. That layout made the transaxle less precise and less notchy than its front-engine counterpart. Tremec’s arrangement smooths some of the gearbox’s rougher edges, but it also removes some mechanical feel. Moving the engine forward or the shifter rearward would address the trade-off, though either would alter the C8’s layout.
Cost remains the obstacle
The manual gearbox carries a steep price: about $75,000 for the transmission alone. Combined with the cost of a Corvette, a converted car would approach the price of a showroom Z06. Tremec says the price should fall as volume rises. The company also says OEMs have shown interest, not necessarily or exclusively General Motors, and that other automakers want a high-torque manual transaxle. No customers were named.
For enthusiasts, the appeal is straightforward: a third pedal and a manually shifted mid-engine Corvette. The demonstration shows the hardware can be packaged, but it does not establish a production program. The business case still depends on demand, pricing and whether an automaker is willing to add a low-volume manual alongside the C8’s dual-clutch automatic.
